While opening one of my SX-64 executive machines i happen to notice this reset modification. Actually i already suspected some modification was done as the reset button on the front, which normally only does a IEC device reset, acts also as a system reset. The J3 connector is disconnected from the P22 “Reset” pins from the IEC board and direct connected to the ‘blue and grey’ modification cable. It works perfectly!
Subscribe!
Meta
Categories
-
128D 1200 6502 6581 ACA1230 ADF Amiga breakfast CF compo D.I.Y. demo diner Dremel EasyFlash Ethernet Floppy Guitar Hero HDD home HxC2001 Jeroen Tel Kickstart knop KS3.1 microIEC Mod mssiah official paddle party Ragtop results ROM RTC scene SDCard SID SX-64 SX64 uIEC unofficial VIC20 x2010 µIEC
WP Cumulus Flash tag cloud by Roy Tanck requires Flash Player 9 or better.
-
Recent Posts
Recent Comments
- Ruben Coolen on Not mine, just some pictures of a PDC Clipper
- Week-52 – CommodoreClub on Reproduction of the SX64 parts by Erwin van Betten
- Phil on Not mine, just some pictures of a PDC Clipper
- Ruben Coolen on Not mine, just some pictures of a PDC Clipper
- #DiskDumpingDecember | 8-bit living… on 64NIC+ ethernet interface on my C64
Lastest CSDB entries
Upcoming parties!
Archives
Blogroll